Sportdevices SP5 dyno electronics & software kit
Test bench electronics Sportdevices SP5 dyno electronics for chassis and engine eddy current brake dyno's including Sportdevices PWS 3.2 brake power supply. This module can be used for all your power and torque measurements in combination with an eddy current brake. The Sportdyno dyno software and updates are free to download. No unnecessary expensive chassis dynamometer software license required!
Sportdevices SP5 eddy current brake test bench dyno electronics & Sportdyno software kit
The Sportdevices SP5 dyno electronics + Sportdyno software set for Eddy Current Brake dynamometers. This dyno kit is the best choice when you are building your own eddy current brake dyno or when you want to convert an old eddy current brake dyno, for example Schenck, Borghi & Saveri, Hofmann, Sun, Bosch, AVL or other. The Sportdevices SP5 dyno electronic kit is also suitable for AWD or 4WD car dyno's. This system takes care of your power measurements, data acquisition and control of the eddy current brake. In addition to power measurements, this is a perfect device for example ECU calibration, emission adjustments and endurance tests.
This dyno test bench electronics and software kit controls the eddy current brake by the PC software (PID control). The new eddy current brake PWS 3.2 power supply module is extremely fast and therefor this set enables you to have very stable control of your (low inertia) eddy current brake without using a flywheel mass. A short introduction of this fast control can been seen in the following video.
Feel free to contact us when help is needed on your project.
1x Hall sensor for flywheel- / Eddy Current brake speed
1x Capacitive rpm clamp for engine speed
1x Load cell
1x Brake Power Supply PWS
1x Set of connection cables
1x USB to serial adapter
Sportdyno software functionality:
- Easy operation via 1 external button or by the PC
Graphs against time, rolling speed / speed and against engine speed
Put up to 8 tests over each other
Calculation of average power between 2 speeds
Calculation of average power of different tests
Zoom in and out
Different correction methods for weather conditions (optional via automatic weather station)
Automatic calculation of gear ratio
Dynoteg makes tuning easy!
- 9 cm
- 22 cm
- 23 cm
- 3,0 kg
- Analog input
- Thermocouple input
- Digital output
- Supply Voltage
- 230 VAC - 50 Hz
- Engine speed input (RPM)
- Roller speed input (RPM)
- Load cell
- Load cell input
- PWM brake control signal
- Om/Off button
- Emergency stop button
- Pulse counter
- Air speed output (PWM)