test bench elektronics sportdevices sp3 (DAQ) torque & power recording
sportdevices sp3 electronics & software kit for test bench
Electronics & software kit SP1 for test bench front side
Electronics & software kit SP1 for test bench rear side
sportdevices sp3 electronics & software kit for test bench

Sportdevices SP3 test bench dyno electronics & software kit

Test bench electronics Sportdevices SP3 with free Sportdyno software. Universally applicable DAQ system to all brake equipped performance test benches / test dyno's (car, motorcycle, scooter, minibike, kart etc.). Acceleration tests are easy to operate from the Sportdyno software or by the supplied start button. This system does not operate or control the brake of the dyno. It only measures the force applied on the load cell.

SD-SP3-4AI2TC
€1.595,00 excl. VAT
Load cell
Quantity

Sportdevices SP3 test bench electronics & Sportdyno software

Sportdevices SP3 test bench electronics and Sportdyno software set for a brake equipped test bench. This electronics and software set is ideal for a self-built brake equipped test bench, but also for converting a test bench equipped with old electronics. For example a Schenck, Sun, Bosch, AVL or another test bench with eddy current brakewater brake or hydraulic brake. This system takes care of your torque and power measurements as well as the data acquisition of your brake equipped dyno. Besides power measurements, this Sportdevices SP3 is a good addition for e.g. ECU calibration, emission control and endurance tests. This set is easy to build and set up. This system takes care of your torque and power measurements. Clear data acquisition by the push of the Start button.

Please note!: This test bench electronics Sportdevices SP3 kit does NOT control the brake of the test bench. This kit only measures the force on the load cell during power measurements of your roller brake tester.

Please contact us for support with your project.

This Sports Devices SP-3 set consists of the following parts:

  • 1x test bench electronics Sportdevices SP3

  • 1x load cell of your choice including extension cable
  • 1x engine speed sensor (capacitive, measurement on spark plug cable)

  • 1x brake speed ​​sensor

  • 1x start / Stop button for testing

  • 1x power cable

  • 1x ground cable

  • 1x RS232 PC communication cable

  • 1x Sportdyno test bench software and English manual

Sportdyno software functionality:

  • Easy operation by 1 external button or by the PC

  • Graphs against time, flywheel mass speed/speed and against engine speed

  • 8 tests overlay possibility 

  • Calculation of average power between 2 speeds

  • Calculation of average power between different tests

  • Zoom in and out

  • Automatic calculation of gear ratio

  • Different correction methods for weather conditions (optional via automatic weather station)

Dynoteg makes tuning easy!

Height
9 cm
Width
15,5 cm
Length
20 cm
Weight
1,8 kg
Analog input
4x
Thermocouple input
2x
Supply Voltage
230 VAC - 50 Hz
Current strength
1.0 A (max.)
Engine speed input (RPM)
1x
Load cell input
1x

Download

Sportdyno 4.0.30.12

Sportdyno dyno software, version 4.0.30.12

Download (2.32M)

Related parts