Tooth belt pulley kit for Dynoteg kart engine dyno
Dynoteg toothbelt pulley kit for the Dynoteg kart engine dyno. This set contains the fiber-reinforced tooth belt and the Dynoteg tooth belt sprockets. You can choose for a set with suits the Rotax kart engine or IAME kart engine.
Dynoteg tooth belt pulley kit for kart engine dyno
Tooth belt pulley kit for testing Rotax Max, Vortex ROK and IAME X30 + KA100 Kart engines on a kart engine dyno test bench.
The front sprocket fits on the original Rotax Max, Vortex ROK or IAME X30 + KA100 kart clutch drum (kit comes without clutch drum).
This tooth belt pulley kit has been developed to test a Rotax Max, Vortex ROK or IAME X30 + KA100 kart engine on the dyno with a tooth belt instead of a chain. This has several benefits:
-very constant and repeatable measurements (resistance of tooth belt is very constant)
-hardly any wear (very long life time)
-no dirt for chain grease
-big cost savings (pulley and belt have a very long life time)
-less noise
Technical data Iame X30 + KA100 Kart dyno test bench tooth belt pulley kit:
-Ratio: 5,6
-center to center distance crankshaft - dyno axle (Iame X30 + KA100): 267 mm
-center to center distance crankshaft - dyno axle (Rotax Max and Vortex ROK): 227 mm
Kit contents:
-Steel front tooth belt pulley/sprocket
-Aluminum rear tooth belt pulley/sprocket (diameter 285mm)
-Rear tooth belt pulley support for 40mm dyno shaft
-Axle key
-Belt
Dynoteg makes tuning easy!
- Length
- Various
- Weight
- 1,9 kg
- Kart engine dyno
- KED-1, KED2 & KED-5
- Max. power
- 30 HP