Sportdevices SP5 AWD chassis dyno electronics & software kit
Test bench electronics version Sportdevices Smartpower SP5 AWD including 2 times Sportdevices PWS 3.2 brake power supply for Eddy Current brake. This module can be used for your AWD chassis dyno in combination with 2 eddy current brakes. The Sportdyno software and updates are free to download. No unnecessary expensive test bench software license required!
Sportdevices SP5 eddy current brake test bench dyno electronics & Sportdyno software kit
The Sportdevices SmartPower SP5 test bench elektronics + Sportdyno dyno software set for Eddy Current Brake dynamometers. This dyno kit is the best choice when you are building your own eddy current brake dyno or when you want to convert an old eddy current brake dyno, for example Schenck, Borghi & Saveri, Hofmann, Sun, Bosch, AVL or other. The Sportdevices SP5 dyno electronic kit is also suitable for AWD or 4WD car dyno's. This system takes care of your power measurements, data acquisition and control of the eddy current brake. In addition to power measurements, this is a perfect device for example ECU calibration, emission adjustments and endurance tests.
This dyno electronics and software kit controls the eddy current brake by the PC software (PID control). The new eddy current brake PWS power supply module is extremely fast and therefor this set enables you to have very stable control of your (low inertia) eddy current brake without using a flywheel mass. A short intorduction of this fast control can been seen in the following video.
Feel free to contact us when help is needed on your project.
This Dynoteg SP5 set contains the following items:
-
2x Hall sensor for flywheel- / Eddy Current brake speed
-
1x Capacitive rpm clamp for engine speed
-
2x Load cell
-
2x Brake Power Supply PWS
-
1x Set of connection cables
-
1x USB to serial adapter
- 1x AWD software synchronisation
Sportdyno software functionality:
- Easy operation via 1 external button or by the PC
-
Graphs against time, rolling speed / speed and against engine speed
-
Put up to 8 tests over each other
-
Calculation of average power between 2 speeds
-
Calculation of average power of different tests
-
Zoom in and out
-
Different correction methods for weather conditions (optional via automatic weather station)
-
Automatic calculation of gear ratio
Dynoteg makes tuning easy!
- Height
- 9 cm
- Width
- 22 cm
- Length
- 23 cm
- Weight
- 3,0 kg
- Analog input
- 6x
- Thermocouple input
- 8x
- Relay output
- 8x
- Supply Voltage
- 230 VAC - 50 Hz
- Engine speed input (RPM)
- 1x
- Roller speed input (RPM)
- 2x
- Load cell
- Yes
- Load cell input
- 2x
- PWM brake control signal
- 2x
- Om/Off button
- Yes
- Emergency stop button
- Yes
- Pulse counter
- 1x
- Air speed output (PWM)
- 1x