Analog connection cable for Sportdevices SP1 / SP3 / SP5 / SP6
Analog connection cable for Sportdevices test bench electronics (DAQ). For example, to connect your AIM LCU-ONE lambda controller module with analog output.
SD-SS-VKA-6-719
€40.00 excl. VAT
Connection cable analog for test bench electronics Sportdevices SP1 / SP3 / SP5 SP6
A connection cable for connecting for example an lambda signal to the Sportdevices SP1 /SP3 / SP5 /SP6 test bench electronic kit. This cable is suitable for an AIM LCU-ONE wide band Lambda controller with 0-5 V output. In case you want to connect a VDO druksensor onto your dyno electronics, please mention it in your purchase order.
Attention: It is not possible to connect an AIM lambda module with 5-pin connector (CAN bus)!
Dynoteg makes tuning easy!
- Length
- 150 cm
- Weight
- 0,17 kg
- Connection 1
- SD 6-pole female
- Connection 2
- 719 4-pole female
- Recommended electronic kit
- Sportdevices SP1 / SP3 / SP5 / SP6
Analog connection cable for Sportdevices test bench electronics (DAQ). For example, to connect your AIM LCU-ONE lambda controller module with analog output.